Townhome Parking Lot PavingDeLand, Florida
Parking lot asphalt paving at a two story townhome community in DeLand, with tight corners, curbed islands and residents living on site. The finished lot is above. The photos from the paving below are labeled.
Project at a glance
- Location
- DeLand, Volusia County
- Property
- Two story townhome community
- Scope
- Parking lot and drive paving
- Equipment
- Paver, dump truck and tandem roller
Day One
What happens on the first day of paving a townhome lot?
Layout comes first, then the first pass. The orange marks on the old pavement in this photo show where the crew planned the edges and the transitions.
Here the paver is just starting along the sidewalk by a brick building. One of the crew works the edge with a lute while two more ride the paver and watch the screed. Behind them sit the red dump truck and a fire hydrant, which the paver has to work around without blocking.
A townhome lot is mostly short runs. Drives curve around islands, stalls tuck in beside buildings, and very little of it is a long straight pull. That changes the plan. The paver makes shorter passes, the trucks wait in tighter spots, and the hand crew does more of the work than on an open commercial lot. M&S Asphalt Paving works through those details before the first truck arrives, and our commercial asphalt paving page covers how we plan community jobs.
Tight Spaces
How do you pave the tight corners of a townhome lot?
You back the paver in as far as it will go, then finish by hand. This little pad sits between curbs, beside a building and a hedge, with no room to turn a machine.
In this frame the paver is backed into the pad while one of the crew tamps the edge and another stands ready with a lute. The curbs are the hard part. The asphalt has to meet them flush all the way around, with no gap for water to get under and no hump for a tire to hit.
Corners like this are where cheap jobs show. A crew in a hurry leaves them thin or ragged, and they break up first. We give them the same two inches as the open lot. Tamping by hand gets the edge tight where the roller cannot reach. It takes longer than the open lot. On a property where people walk past these pads every day, it is worth every minute.
The Crew
How do residents get around while their community lot is paved?
We close one part of the lot at a time and keep a way in and out open. Residents always know where to park that day.
This photo shows why it takes the whole crew. Four people work around the paver with lutes while a dump truck feeds it and the tandem roller waits at the left. The wet streaks on the new asphalt come from the roller. It sprays its drums with water. Otherwise the hot mix sticks. Too much water cools the mat, and too little lets the mix pull up in chunks, so the operator watches it the whole time.
DeLand townhome and HOA communities often sit on older pavement laid when the buildings went up. Most of them show the same wear: cracked drives, faded stalls and edges breaking up along the curbs. Repaving gives the board a clean start. Our asphalt paving in DeLand page covers the neighborhoods we work in around the city.
The Result
What does the finished townhome lot look like?
These are the same drives from the photos above, finished. The surface is even and black, it runs tight to the sidewalk and the curbs, and the drive sweeps cleanly around the islands. Keep it that way with a coat of asphalt sealcoating once the new surface has cured, and the Florida sun has a much harder time fading it.
Want to see another DeLand job?
This cul-de-sac in DeLand was resurfaced edge to edge, with the paver working through the curve and the roller finishing tight to the curb.
Does your community lot need repaving?
Call and tell us about the property. We walk the lot, look at the curbs, the islands and the drainage, then give you a straight price with the section plan written out, in English or Spanish.
Call us today (386) 215-7466